Tikka T3x Superlite SS - weights and setup pics - Rokslide Forum

The 6-Minute Rule for Tikka T3 / T3X Pre Fit Barrel

5oz/ 2. 9oz/ 3. 2oz The from the top of the action/ receiver to the bottom of the scope tube at the respective installing place determined center to center. Front hole spacing:. 860 inches (21. 84mm) Rear hole spacing:. 860 inches (21. 84mm) Sold in pairs.

An Outdoorsman's Dream: Meet the Tikka T3x Artic Rifle - The National Interest

(6-48 Screws/ T-15) Streamlined method of determining required scope ring height Utilizing some sort of shim (i. e. coins, washers, magnets) stack up the required variety of shims to attain wanted scope height. Verify last height does not interfere with operation of bolt handle. Procedure the last stack of shims.

do not hesitate to contact our technical support team for assistance on your Tikka T3 Scope Installs. 803-854-5700 17-20 in/lb on ring cap screws. Do not exceed scope maker's permitted torque specifications on main tube. Always advised to validate with Full Article allowed torques to prevent marking or damage to scope tube.

The Best Strategy To Use For Tikka T3 and T3x — Value, Performance, Upgradability

Torque can depend upon the receiver. Please inspect with the rifle maker (Tikka) to verify allowable torque into receiver. Constantly ensure your torque wrench is calibrated, Talley Mfg is not accountable for damage caused to scopes or guns due to over torquing. Although not always needed, utilizing Loctite for the screws entering the receiver is perfectly fine.

We do not advise using Loctite on the ring screws. Always test fit before applying any Loctite.

The store will not work correctly in the case when cookies are handicapped. $799. 00 799 $799. 00 799 To see product rate, add this item to your cart. You can constantly eliminate it later on. Barrel Length: 24. 3" Twist Rate: 1:8" Modular artificial stock Recoil pad Receiver presents an expanded angular ejection port that makes it much easier to feed one cartridge at a time.